Calacatta Marble Shower Remodel
About this project
This shower remodel in a Sutterville post-war home involved full demolition of the original tile installation, which had been set over standard drywall with no waterproofing membrane. The original tile was failing at the base of the shower walls due to years of water infiltration. After tear-out, we installed cement board throughout the shower enclosure, applied a sheet-applied waterproofing membrane with fabric tape at all corners and seams, and built a mortar bed shower floor sloped at 1/4 inch per foot toward the center drain before any tile was set.
The wall tile is a 12x24 Calacatta marble-look porcelain set in a vertical stack bond pattern. The floor is a round penny mosaic on mesh backing, which provides grip and visual contrast against the large-format wall tile. The built-in niche and bench were tiled with the same wall tile, with the niche shelf sloped forward slightly to drain water out rather than pooling on the shelf surface.
What we did
Full demolition to studs, substrate assessment, cement board installation throughout shower enclosure
Sheet-applied waterproofing membrane with fabric tape at corners, seams, and drain transition
Mortar bed shower floor built to proper slope, Calacatta porcelain wall tile set in vertical stack, penny mosaic floor installed with full mortar coverage under mesh
Grout and silicone caulk at all change-of-plane joints, final inspection
To discuss a similar bathroom tile project in Sutterville or nearby, call (916) 999-5399.