Dual-Head Walk-In Shower in Sutterville
About this project
This large walk-in shower in a Sutterville home was designed around a dual rain showerhead configuration, which required plumbing rough-in at two points in the ceiling before tile work began. Our scope was the tile installation — the plumbing was handled by a licensed plumber, and we coordinated the tile schedule to begin after the rough-in was inspected and approved.
The wall tile is a large-format Calacatta marble-look porcelain, 24x48 panels set in a horizontal orientation. Tiles of this size require a medium-bed polymer-modified mortar and back-buttering to achieve the 95% coverage requirement in wet areas. The grout joint is 1/16 inch, which required rectified tile — each tile in the batch was confirmed to be within tolerance before installation began. The consistent joint width gives the installation a clean, continuous look that suits the scale of the shower enclosure.
What we did
Cement board installation, coordination with plumber for ceiling penetration waterproofing
Sheet waterproofing membrane applied to all walls and floor, seams and corners treated with fabric tape
24x48 rectified Calacatta porcelain set with medium-bed mortar and back-buttering, 1/16-inch joints
Unsanded grout in tight joints, silicone at all change-of-plane transitions
For large shower tile installations in Sutterville, call (916) 999-5399.